DG200-2S (Single-phase)

Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.

Open Generator Set
Enclosure

Features

  • Engine

    Engine

    • Four-stroke-cycle gas engine combines consistent performance and excellent fuel economy with minimum weight
  • Alternator

    Alternator

    • Matched to the performance and output characteristics of Cat engines
    • Industry leading mechanical and electrical design
    • Industry leading motor starting capabilities
    • High Efficiency
  • EMCP Control Panel

    EMCP Control Panel

    • User-friendly interface and navigation
    • Scalable system to meet a wide range of installation requirement
    • Expansion modules and site-specific programming for specific customer requirements
  • Design Criteria

    Design Criteria

    • The generator set facilitates compliance with NFPA 110 and meets ISO 8528-5 requirements for transient response
    • Cooling system designed to operate in 50˚C/122˚F ambient temperatures with an air flow restriction of 0.5 in. water
  • UL 2200 / CSA - Optional

    UL 2200 / CSA - Optional

    • UL 2200 Listed packages
    • CSA Certified
    • Certain restrictions may apply
    • Consult with your Cat® Dealer
  • Worldwide Product Support

    Worldwide Product Support

    • Cat dealers have over 1,800 dealer branch stores operating in 200 countries
    • Your local Cat dealer provides extensive post-sale support, including maintenance and repair agreements

Specifications

Units for specifications

Generator Set Specifications

Frequency 60 Hz
Natural Gas Rating 200 eKW
Emissions/Fuel Strategy U.S. EPA Certified for Non-Emergency Application
Displacement 864.71 in³ 14.17 l
Fuel Type Natural Gas
Speed 1800 rpm

Engine Specifications

Engine Model 14.2 L Spark - Ignited
Fuel System Carburetor, Down Draft
Aspiration Turbocharged-Aftercooled
Governor Type Electronic
Compression Ratio 9.5:1
Bore 5,31 in 134.87 mm
Stroke 6.5 in 165.1 mm

Generator Set Dimensions

Length 127.95 in 3250 mm
Width 52.93 in 1344.5 mm
Height 67.37 in 1711.2 mm
Weight 5756 lb 2610.9 kg

Standard Equipment

Cooling

  • Factory-installed radiator
  • Closed coolant recovery system
  • 50/50 Ethylene glycol antifreeze
  • Standard ambient temperatures up to 50°C (122°F)
  • Radiator and cooling fan complete with protective guards

Air Inlet

  • Single element air filter

Fuel

  • Fuel pressure test po
  • Primary and secondary fuel shut-off
  • Low fuel pressure switch
  • Dual lock off valves
  • NPT connection
  • Natural Gas or LP Vapor

Exhaust

  • Exhaust outlet with 3” pipe

Generator

  • Full load capacity alternator
  • Permanent magnet excitation
  • Class H insulation material
  • Integrated Voltage Regulator
  • Matched to the performance and output characteristics of Cat engines
  • IP23 Protection

Controls

  • EMCP 4.2 Series generator set controller

Mounting

  • Vibration isolaton (puck type)
  • Rubber vibration isolators

Electric Starting and/or Prelube

  • Engine electrical system
  • Solenoid activated starter motor
  • Battery cables

Electric Power - Package Serial Number Prefix

  • Battery charging alternator

Governor

  • Electronic governor (non adjustable)

Control Panel

  • EMCP 4.2 Series generator set controller

Starting/Charging

  • 12 volt starting motor
  • Batteries with rack and cables

Optional Equipment

Starting/Charging

  • Battery charger – UL Listed 10 amp
  • Charging alternator
  • Jacket water heater
  • Battery heater

General

  • UL 2200 package
  • Enclosures: sound attenuated, weather protective
  • CSA Certification
  • Suitable for Use as Service Equipment (SUSE)
  • Automatic transfer switches (ATS)

Generator

  • Shunt trip and auxiliary contact breaker
  • Thermal magnetic or electronic trip MCCBs
  • Anti-condensation heater
  • Excitation: [ ] Permanent Magnet Excited (PM)
  • Anti-condensation heater
  • Oversize and premium generators
Enclosure

Documents