2005 JLG INDUSTRIES, INC. 600S 6,789 engine hrs

Features

  • AMBERBEACON
  • CAT DIESEL
  • COLDWEATHER START KIT
  • SKY POWER 7.5 KW GENSET

Condition

Cleaning Required Yes There is oil all over on machine and metal residue by basket area
Operations and Maintenance Manuals Present No
S.O.S. Taken No
Crankcase Guard / Battery Box
● ● ●
Eng. Enclose Hood / Stack
● ●
Hood latch is loose on left side. Hood seal is falling off on the right side
Fiberglass
● ● ●
Fuel Tank
● ● ●
Grab Irons
● ● ●
Main Frame Welds
● ● ●
Paint
● ●
Paint is faded and scratched.
Plastic
● ● ●
Radiator Grill & Shroud
● ● ●
Sheet Metal
● ●
Sheet metal is bent above the counter weight

Inspection Sticker Dated No No inspection sticker found on machine
Safety Decals In Place Yes
Safety Decals Legible No There are a few decals that are worn off or hard to read
Back Up Alarm
● ● ●
Horn
● ● ●

Current Parts Manual No
Current Safety Manual No
Dash Console
The dash in basket is unreadable
Foot Switch
● ●
Machine sometimes acts as if foot switch is not being pressed
Meter
● ● ●
Switches
● ●
The travel switch is broken

Anti-Freeze Color Green  
Fuel Level 1/4  
Notes - ENGINE Engine is very slow on reving up when in operation and revs down during operation  
Oil Pressure (H/L/N) Normal  
Smoke (B/D/L/W) Normal  
Compression in Radiator No
Fluid Levels OK? Yes
Has Engine been rebuilt? No
Knocking No
Water in Oil No
Air Cleaner
● ● ●
Belts / Pulleys
● ●
The generator is missing the belt
Engine Supports
Engine mounts loose and worn out
Exhaust / Muffler
● ● ●
Fuel Injection System
● ● ●
Governor
● ● ●
Oil Filter Condition (CUT)
● ● ●
Overall Operating Condition - ENGINE
● ● ●

Leaks - COOLING SYSTEM No
Coolers
● ● ●
Fan
● ● ●
Fan Drive
● ● ●
Hoses
● ● ●
Radiator
● ● ●
Water Pump
● ● ●

Alternator
● ● ●
Batteries / Cables
● ● ●
Pre-Heater
● ● ●
Starter
● ● ●
Wiring
● ● ●

Front Axle - STEERING
● ●
Lines / Fittings
● ●
Lines are cracked
Pumps
● ●
Steering Controls
● ● ●
Steering Cylinder
● ●
Steering cylinder leaking
Steering Linkage
● ● ●
Tie Rods / Rod Ends
● ● ●
Valves
● ● ●

Leaks - HYDRAULICS Yes There is a leaking under machine. Needs troubleshooting to find leak
Control Linkage
● ● ●
Filter Condition (CUT)
● ● ●
Hose fittings
● ● ●
Hose Lines
● ●
Boom hoses are all extremely tight and starting to wear through
Lift Cylinders
● ●
The boom cylinder is leaking. The basket raise cylinder is leaking g
Overall Operating Condition - HYDRAULICS
● ●
Pump & Valves
● ●
There is a leak around the pump area on the back of engine. Will need troubleshooting to find leak
Tank
● ● ●
Tilt Cylinder
● ●
The boom lift cylinder is leaking

Boom Length (Actual Length) 50  
Boom Condition
● ● ●
Boom Pins
● ● ●
Pins & Bushings
● ● ●

Lanyard anchors Yes
Lanyard anchors Labeled Yes
Floor
● ●
Floor dented
Gate / Latch
● ● ●
Guards
● ● ●
Rails
● ● ●

Drive Motors
● ● ●
Front Axle - FINAL DRIVES
● ●
Front Final Drives
● ●
The front right final leaking
Rear Axle
● ●
Rear Final Drives
● ●
The left rear final leaking. The right rear final starting to leak
Wheel Lugs & Rims
● ●

Spare No
Tires Needed No
Left Front
Recapped: No
Tread Cuts Chunks: No
Side Cuts Section: Yes
Left Rear
Recapped: No
Tread Cuts Chunks: No
Side Cuts Section: Yes
Right Front
Recapped: No
Tread Cuts Chunks: No
Side Cuts Section: No
Right Rear
Recapped: No
Tread Cuts Chunks: No
Side Cuts Section: Yes

Axle Oscillation
● ● ●

Swing Drive and Gear Secure Yes
Swing Bolts
● ● ●
Swing Drive and Gear
● ●
The swing motor is leaking oil
Turntable bearing
● ● ●
Turntable Bearing Lubrication
● ● ●

Request Information

For used equipment call (952) 843-3582 or come by today and experience our superior service and selection. We look forward to serving you!
Z CAT icon